Xerox WorkCentre 5020 Service Documentation page 90

6. Disconnect the ROS connectors (Figure 3).
1 Disconnect the Ground connectors (2).
2 Disconnect the connectors (2).
3 Disconnect the connector.
4 Remove the wire harness from the hook.
Repairs and Adjustments
REP 3.1.1
Figure 3
7. Remove the ROS (Figure 4).
1 Remove the Tapping Screws (5).
2 Remove the ROS.
Replacement
1. To install, do the removal steps in reverse order.
NOTE: When powering up to perform operations with the ROS installed, read the warning
label pasted on the ROS before proceeding with the operation.
July, 2007
4-18
Figure 4
Initial Issue
WorkCentre 5020