Rep 7.1 Tray 1 Feed Assembly - Xerox WorkCentre 4150 Service Manual

REP 7.1 Tray 1 Feed Assembly

Parts List on PL 8.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
NOTE: A short, crosshead screwdriver with a narrow handle, PL 26.10 Item 2 is required to
remove the 4 screws that secure the tray 1 feed assembly. The screwdriver is supplied in the
service training kit.
1. Remove paper tray 1.
2. Remove the main drive assembly, REP 4.1.
3. Remove the tray feed gear and the retard roll gear, Figure 1.
Figure 1 Gear removal
WorkCentre 4150
4. Remove the feed head support spring and retard roll, Figure 2.
2
Remove the tray feed
gear and the retard roll
gear.
1
Remove the E-clip.
September 2006
4-23
2
Remove the retard
roll.
1
Remove the feed head support
spring.
Figure 2 Spring and retard pad removal
Repairs and Adjustments
REP 7.1