Error
Code
Error Name/Explanation/I/O Diagnostic Codes/Check Items
Error Name
STM Regi SNR on JAM
Explanation
•
When feeding paper from the STM, timeout between Tray1 Feed Sensor ON and IOT Registration Sensor ON.
I/O Diagnostic Codes (How to Enter the Diagnostic Mode)
•
[08-05] IOT Registration Sensor
•
[08-10] IOT Registration Clutch
Check Items
•
Take Away Roll 1 dirty, contaminated with paper dust, worn, or faulty
•
IOT Registration Sensor dirty and Sensor Actuator deformed or damaged
•
Paper damaged, not within specification, or not loaded correctly
•
Foreign matter, burrs, or paper in the paper path
•
Drive gear worn or damaged
C2-3
•
IOT Registration Clutch faulty
•
Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Tray 1 Feed Sensor
(PL 2.5) (REP 2.5.1).
–
Wire between Tray 1 Feed Sensor J158-3 ( P/J158) and LVPS J501-6 ( P/J502)
–
Wire between Tray 1 Feed Sensor J158-2 and LVPS J501-7
–
Wire between Tray 1 Feed Sensor J158-1 and LVPS J501-8
•
Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the IOT Registration Sen-
sor (PL 2.9).
–
Wire between Tray 1 Feed Sensor J156-3 ( P/J156) and LVPS J503-1 ( P/J503)
–
Wire between Tray 1 Feed Sensor J156-2 and LVPS J503-2
–
Wire between Tray 1 Feed Sensor J156-1 and LVPS J503-3
•
Replace the IOT Registration Clutch (PL 2.9) and the AIOC PWB (PL 8.1) (REP 8.1.1) in that order.
Error Name
No paper in the selected paper tray (Tray1)
Explanation
•
No paper is detected in Tray1 when ATS function is disabled and Tray1 is selected during a copy job.
•
No paper is detected in Tray1 when Tray1 is selected during a print job (the paper size setting matches the one specified for the job).
I/O Diagnostic Codes
[07-07] Tray1 No Paper Sensor
Check Items
•
Press the [Stop] button on the Control Panel.
C5-0
•
Check the tray to see if it is empty; if it is, add paper specified by the job.
•
Tray1 No Paper Sensor dirty and Sensor Actuator deformed or damaged
•
Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Tray 1 No Paper Sen-
sor (PL 2.7) (REP 2.7.1).
–
Wire between Tray1 No Paper Sensor J157-3 ( P/J157) and LVPS J501-3 ( P/J501)
–
Wire between Tray1 No Paper Sensor J157-2 and LVPS J501-4
–
Wire between Tray1 No Paper Sensor J157-1 and LVPS J501-5
•
Replace the AIOC PWB (PL 8.1) (REP 8.1.1).
Status Indicator RAPS
July, 2007
2-10
Record in
Error Log
RAP
BSD
CH8.1
Figure 1
O
-
CH8.4
Figure 4
CH7.1
X
-
Figure 1
Initial Issue
WorkCentre 5020