Honeywell Galaxy Flex V3 Series Installer Manual page 95

Galaxy Flex Installer Manual
To select a preset, enter an option number from the tables below:
Option
The operating range for each resistance value is shown in Appendix H: Resistance tables on
page 255.
When a preset is selected it sets the zone resistance range used by every zone on the system.
Each zone on the system can be further customised to a specific preset by using the
Resistance Select [52.9] option.
Set Confirm [51.47]
Use this option to cause the system to emit a short double beep when the system/group has
set. There are three options:
0=Off
1=Alert on Set
2=Alert on Comm
Alarm Limits [51.48]
Use this parameter to program the maximum number of alarms, per group, which may be
transmitted to an Alarm Receiving Centre in any set period. There are three options:
Double balanced
01 1k
02 -
03 2k2
04 -
05 4k7
06 -
07 5k6
08 -
09 3k3
10 -
11 1k fault
12 -
13 1k N/O
14 -
15 -
16 2k
Table 2 Resistance values
No indication.
A double beep when the system has set.
A double beep after a successful signal to the ARC that setting has
occurred.
End of line Split resistance
- -
1k -
- -
2k2 -
- -
4k7 -
- -
5k6 -
- -
3k3 -
- -
1k fault -
- -
0k N/C -
- 2k2, 4k7
- -
Parameters [51]
95