Honeywell Galaxy Flex V3 Series Installer Manual page 111

Galaxy Flex Installer Manual
Scroll through the available channels, and then press
channel.
14=Fire Confirm
Use this attribute to enable this zone to be used as a fire confirm. A Fire zone with this
attribute enabled must be activated first.
15=Camera
Use this attribute to link the zone to a camera. When an alarm activation occurs, the camera
will record an image sequence for alarm verification.
Batch learn [52.3]
Use this option to learn a series of wireless detectors onto the system in a single operation.
Devices are added sequentially from the selected zone address.
Select a start zone address and press ent.
1.
2. Insert the battery in the first detector and activate the tamper switch. The serial number
of the detector is recorded and displayed for 2 seconds. The panel provides a
confirming beep when each wireless detector is successfully learned.
If the signal strength is less than 3/10, the message Signal strength too low is
displayed for 2 seconds.
3. Repeat step 2 on all the remaining wireless detectors in turn.
Camera Zones [52.4]
Use this option to view only the zones that belong to camera PIRs
Zone Function menu
01 = Final
02 = Exit
03 = Intruder
05 = Security
07 = Entry
08 = Push Set
09 = Keyswitch
10 = Secure Final
11 = Part Final
12 = Part Entry
13 = PA
14 = PA Silent
15 = PA Delay
16 = PA Delay Silent
18 = Spare
19 = Fire
20 = Tamper
22 = Beam Pair
23 = Battery Low
24 = Line Fail
25 = AC Fail
26 = Log
28 = Video
29 = Video Exit
Program Zones [52]
to select the available audio
ent
32 = Set Log
33 = Custom-A
34 = Custom-B
39 = Keyswitch Reset
40 = Bell Fail
41 = Intr Low
42 = Intr High
43 = PSU Fault
44 = Fault
45 = Entry 2
53 = Monitor
111