Honeywell Galaxy Flex V3 Series Installer Manual page 151

Galaxy Flex Installer Manual
Note: For installation fault finding when setting up a GSM or GPRS connection, please see
the Diagnostics.menu [61.1.6.5]. For a quick guide to setting up the GSM/GPRS
module, see the GSM module section in Appendix G.
GSM/GPRS SIM PIN [56.3.2.6]
This is the PIN to access the SIM card (if required).
GSM/GPRS SMS Receipt [56.3.2.7]
This option allows a delivery receipt to be requested from the network for SMS. If a
delivery receipt is returned the panel will record this in the event log.
0=Disabled, 1=Enabled.
Ethernet DHCP [56.3.3.1]
If DHCP is enabled the module attempts to configure itself automatically on the network.
For manual configuration, set this to disabled.
Ethernet IP Address [56.3.3.2]
This must be a unique, static IP address. The dot separator is automatically added after each
sequence of three numbers or it can be manually added by pressing . The address is
provided by your IT administrator.
Ethernet Gateway [56.3.3.3]
Enter the IP address of the gateway router connected to the Ethernet local area network. This
information is supplied by your IT administrator.
Ethernet Network Mask [56.3.3.4]
The network mask identifies the class of network being used. This field masks off the parts
of the gateway IP address that are common and not required for specific identification of the
Ethernet module. This information is supplied by your IT administrator.
Ethernet Encryption [56.3.3.5]
See GPRS Encrypt [56.3.2.3.1] for details.
Ethernet line fail [56.3.3.6]
Enables or disables network availability monitoring.
Ethernet IP Check configuration [56.3.3.7]
See GPRS IP Check configuration [56.3.2.2.4] for details.
Communications [56]
151