Honeywell Galaxy Flex V3 Series Installer Manual page 145

Galaxy Flex Installer Manual
Triggers [56.1.2.1.2]
When you select the option, the first trigger event is displayed (see Table 10 for a list of
available triggers). These are the events and alarms that are transmitted to the ARC or
computer. If the trigger status is set to 1=Enabled, an event activation results in
transmission of the event details to the receiver. The triggers are available to the Telecom
module, the USB module and the Ethernet module.
To enable or disable a trigger event:
1. Scroll to the trigger you want to enable or disable, and then press
2. Press 1 to enable or 0 to disable, and then press
AUX 1 Report [56.1.2.2]
Use this section to configure an independent sequence of receiver reporting where dual
notification is required. Programming of Secondary Reporting is identical to ARC
Reporting.
Aux 2 Report [56.1.2.3]
Aux 3 Report [56.1.2.4]
Use these sections to programme any additional, lower priority alarm signalling
Aux 2 and Aux 3 are programmed as per the ARC Report [56.1.2.1].
DTMF Report [56.1.2.5]
Use this section to configure alarm signalling using DTMF format. It is configured in the
same way as ARC Reports but uses channel triggers instead of Event Triggers. For each of
the 8 channels there are four options: 1 = Op Function, 2 = Output Mode, 3 = Op Polarity
and 4 = Restoral. The first three options are programmed in exactly the same way as outputs.
See Program Outputs [53] for details. 4 = Restoral has these sub-options: 0 = Alarm Only
and 1 = Restore.
Note: Use DTMF receivers only in this sequence.
Trigger Event
01=PA/Duress
02=Intruder
03=Security
04=Custom Zones
05=Fire
06=Set Fault
07=Omit
08=Tamper
09=Setting
10=Reset/Cancel
Table 10 Trigger Events
Communications [56]
Trigger Event
11=Modules/Comms
12=Elec. Status
13=Menu Access
14=Trouble
15=Log Zone
16=Max Tag
17=Zone Restoral
18=RF Supervision
19=Fault
.
ent
.
ent
145