Honeywell Galaxy Flex V3 Series Installer Manual page 106

Program Zones [52]
Press to toggle the descriptor to reveal the status of the chime, omit and part attributes. If
#
the attribute is enabled, the initial attribute letter is displayed, if it is disabled, a dash (–) is
shown. For example, chime, part and omit enabled display as COP, if omit is disabled the
display would be C – P.
Use or to scroll through the zones, or enter the address of a specific zone.
A B
to programme a zone. The first programming attribute 1=Function is displayed.
Press
ent
Attributes
On entering programming mode for a zone as described above, use
attribute, or enter an attribute number directly, and then press
Press to save the programming and return to the attribute selection level.
ent
Press at any time when assigning attributes 1 and 3 to 13 to abort programming and
esc
return to the attribute selection level. When the attribute is 2=Descriptor the assigned alpha-
numeric text is saved.
1=Function
The Function attribute displays the address and the current function of the selected zone
along with the zone function reference number. You can scroll through the zone functions or
you can enter a zone function reference number directly, for example, enter 19 to display
zone function 19=FIRE. For zone function details, see Zone Function menu on page 111
and subsequent pages.
Once the required zone function is displayed, press
2=Descriptor
Use this attribute to add an alpha-numeric descriptor of up to 16 characters to a zone. You
can use the inbuilt character set and/or library options.
When you enter the attribute, the current descriptor (blank by default) is displayed on the top
line and an underscore shows where the next character will be positioned. A selection of the
alphabet is shown on the bottom line and the cursor flashes on the letter L.
Press to erase the characters already assigned to the descriptor.
Use or to move the alphabet left or right until the required character is positioned
A B
underneath the flashing cursor. When the required character is in position press
the character to the descriptor on the top line. Repeat this procedure to assemble the required
zone descriptor.
Text Case and Library
When you enter the attribute the alpha-numeric characters are presented in upper case. Press
to toggle the characters to lower case.
#
Press when the lower case alphanumeric characters are displayed to toggle to the library
#
words. Use or to scroll through the words, or enter a reference number directly (see
A B
Appendix A: Library). When the required word is displayed, press
descriptor.
106
Galaxy Flex Installer Manual
or
A
.
ent
to assign it to the zone.
ent
to copy it to the
ent
to scroll to an
B
to copy
ent