Honeywell Galaxy Flex V3 Series Installer Manual page 64

Codes [42, Quick Menu 7]
To assign a level to a user:
1. Type the level to be assigned.
2. Press .
ent
EN50131-1
Level
†
1 0
†
2 1
†
2 2
2 3
2 4
2 5
‡
2 6
‡
3 7
‡
3 8
† No access to menu functions
‡ The manager, engineer and remote codes (the last three codes on the system) have fixed
types which cannot be reprogrammed.
Note: All levels except Guard 0 can change their own PIN.
Duress Code
Entry of a Duress Code sends a signal to the monitoring station to indicate a user has been
forced to operate the system under duress. Any user on the system can be designated as a
Duress Code. There is no limit to the number of users that can be assigned as Duress Codes.
To assign a Duress Code:
In the Modify Level option, press
Code.
To assign a User Code as duress:
Enable the Duress User [51.77] option.
Quick Menu
All user codes default to the quick menu. This menu is made up of a selection of ten options
(0 – 9) from the full menu. Access to the quick menu is controlled by the user type. Any
user can be upgraded from the quick menu to the full menu by assigning a
while the Modify Type option is accessed. Therefore a user with type 5 would have access
to the full menu from options 11 – 32. It is not possible to access both menus at the same
time.
To reprogram the options contained in the quick menu refer to Quick Menu [59].
Note: The master manager code defaults to the full menu.
64
Level Access Availability
Guard Entered into event memory – no other option
Guard Can only set the system and change own PIN
Caretaker Can only set and unset the system and change own PIN
Users Menu options 11 to 19
Users Menu options 11 to 25
Users Menu options 11 to 32
Manager Menu options 11 to 48
Engineer Menu options 11 to 72
Remote Menu options 11 to 72
. The current user code is assigned as a Duress
#
Galaxy Flex Installer Manual
to the user