Show Snmp Host; Create Snmp V6Host - D-Link DGS-1100-06/ME Cli Reference Manual

DGS-1100-06/ME:5#

show snmp host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1100-06/ME:5#show snmp host
Command: show snmp host
SNMP Host Table
(Maximum Entries : 10)
Host IP Address
------------------------
10.90.90.22
Total Entries : 1
DGS-1100-06/ME:5#

create snmp v6host

Purpose
Syntax
Description
Parameters
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
To display the recipient of SNMP traps generated by the Switch's
SNMP agent.
show snmp host {<ipaddr>}
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps generated by the Switch's
SNMP agent.
<ipaddr> − The IP address of a remote SNMP manager that
receives SNMP traps generated by the Switch's SNMP agent.
None.
SNMP Version
---------------------
V3-NoAuthNoPriv
To create a recipient of SNMP traps generated by the Switch's
SNMP agent.
create snmp v6host <ip6_addr> [v1 <username 32> | v2c
<username 32> | v3 [noauth_nopriv | auth_nopriv | auth_priv]
<username 32>] {InterfaceName <string 20>}
The create snmp v6host command creates a recipient of SNMP
traps generated by the Switch's SNMP agent.
<ipv6_addr> − The IPv6 address of the remote management station
to serve as the SNMP host for the Switch.
v1 – Specifies that SNMP version 1 is to be used. The Simple
Network Management Protocol (SNMP), version 1, is a network
management protocol that provides a means to monitor and control
network devices.
v2c – Specifies that SNMP version 2c is to be used. The SNMP v2c
supports both centralized and distributed network management
strategies. It includes improvements in the Structure of Management
Information (SMI) and adds some security features.
Community Name/SNMPv3 User Name
-------------------------------------------------------
dlink
52