Config Mac_Notification; Config Mac_Notification Ports - D-Link DGS-1100-06/ME Cli Reference Manual

Parameters
Restrictions
Example usage:
To disable MAC notification without changing basic configuration:

config mac_notification

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch's MAC address table notification global settings:

config mac_notification ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
address notification without changing configuration.
None.
Only administrator or operator-level users can issue this command
DGS-1100-06/ME:5#disable mac_notification
Command: disable mac_notification
Success.
DGS-1100-06/ME:5#
Used to configure MAC address notification.
config mac_notification [interval <int 1-2147483647> |
historysize <int 1-500>]
The config mac_notification command is used to monitor MAC
addresses learned and entered into the FDB.
interval <int 1-2147483647> − The time in seconds between
notifications. The user may choose an interval between 1 and
2147483647 seconds.
historysize <1-500> − The maximum number of entries listed in the
history log used for notification.
Only administrator or operator-level users can issue this command
DGS-1100-06/ME:5#config mac_notification interval 1
Command: config mac_notification interval 1
Success.
DGS-1100-06/ME:5#
Used to configure MAC address notification status settings.
config mac_notification ports [<portlist> | all] [enable | disable]
The config mac_notification ports command is used to monitor
MAC addresses learned and entered into the FDB.
<portlist> − Specifies a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC
address table notification on the Switch.
Only administrator or operator-level users can issue this command
137