Download/Upload Commands; Download - D-Link DGS-1100-06/ME Cli Reference Manual

The Download/Upload commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

download

upload
Each command is listed in detail, as follows:
download
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To download a firmware file:
DGS-1100-06/ME:5#download firmware 1.1.1.23 1\dgs_1100-06me.ros
Command: download firmware 1.1.1.23 1\ dgs_1100-06me.ros
01–Jan–2000 01:19:48 %COPY–I–FILECPY: Files Copy – source URL tftp://1.1.1.23 /1\
dgs_1100-06me.ros destination URL Unit all flash://image
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide

DOWNLOAD/UPLOAD COMMANDS

Parameter
[configuration [<ipaddr> | <ipv6_addr>] <path_filename 64>] | [firmware
[<ipaddr> | <ipv6_addr>] <string 64>]
[[firmware [<ipaddr> | <ipv6_addr>] <path_filename 64>] | [cfg_toTFTP [<ipaddr>
| <ipv6_addr>] <path_filename 64> config_id <value 1-2>] | [log_toTFTP
[<ipaddr> | <ipv6_addr>] <path_filename 64>]]
To download and install a firmware, boot, or switch configuration file
from a TFTP server.
download [configuration [<ipaddr> | <ipv6_addr>]
<path_filename 64>] | [firmware [<ipaddr> | <ipv6_addr>]
<string 64>]
The download command downloads a firmware, boot, or switch
configuration file from a TFTP server.
configuration − Downloads a switch configuration file from a TFTP
server.
<ipaddr> − The IPv4 address of the TFTP server.
<ipv6_addr> − The IPv6 address of the TFTP server.
<path_filename 64> − The DOS path and filename of the switch
configuration file, up to 64 characters, on the TFTP server. For
example, C:\31xx.had.
startup − Indicates the Configuration file is to be downloaded to the
startup config.
firmware − Downloads and installs firmware on the Switch from a
TFTP server.
<string 64> − The DOS path and filename of the firmware file, up to
64 characters, on the TFTP server. For example, C:\31xx.had.
Only Administrator or operator-level users can issue this command.
71
11