Show Snmp V6Host; Enable Snmp Traps - D-Link DGS-1100-06/ME Cli Reference Manual

show snmp v6host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1100-06/ME:5#show snmp v6host
Command: show snmp v6host
SNMP Host Table
(Maximum Entries : 10)
Host IP Address
------------------------------------
3000::1
Success!
DGS-1100-06/ME:5#

enable snmp traps

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable SNMP trap support on the Switch:
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Command: delete snmp host 10.90.90.22
Success!
DGS-1100-06/ME:5#
To display the recipient of SNMP traps generated by the Switch's
SNMP agent.
show snmp v6host {<ip6_addr>}
The show snmp host command is used to display the IPv6
addresses and configuration information of remote SNMP managers
that are designated as recipients of SNMP traps generated by the
Switch's SNMP agent.
<ip6_addr> − The IPv6 address of a remote SNMP manager that
receives SNMP traps generated by the Switch's SNMP agent.
None.
To enable SNMP trap support.
enable snmp traps
The enable snmp traps command enables SNMP trap support on
the Switch.
None.
Only Administrator or operator-level users can issue this command
DGS-1100-06/ME:5#enable snmp traps
SNMP Version Community or User Name
-------------------- -------------------------------------
V3-NoAuthNoPriv dlink
54