Show Lldp Mgt_Addr; Show Lldp Statistics - D-Link DGS-1100-06/ME Cli Reference Manual

Restrictions
Example usage:
To configure LLDP mac_phy_configuration status:
DGS-1100-06/ME:5#config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Command: config lldp ports all dot1_tlv_vlan_name vlanid 1 disable
Success!
DGS-1100-06/ME:5#

show lldp mgt_addr

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the LLDP management address advertisement:
DGS-1100-06/ME:5#show lldp mgt_addr
Command: show lldp mgt_addr
Address : 1
------------------------------------------------------------------------------
Total Address : 1
DGS-1100-06/ME:5#

show lldp statistics

Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
vlanid <vidlist> –The vid of the VLAN to be configured.
Only Administrator or operator-level users can issue this command.
To display the Link Layer Discovery Protocol (LLDP) configuration
that is advertised from a specific port.
show lldp mgt_addr {ipv4 <ipaddr> | ipv6 <ipv6addr>}
The show lldp mgt_addr command displays the information
regarding the IPv4 or IPv6 address.
ipv4 <ipaddr> | ipv6 <ipv6addr> – Specifies the lldp IPv4 or IPv6
address to be displayed.
None.
Subtype
Address
IF Type
OID
Advertising Ports
To display the Link Layer Discovery Protocol (LLDP) statistics for the
specified ports.
show lldp statistics {ports <portlist>}
The show lldp statistics command displays the statistics of LLDP
on the Switch.
{ports <portlist> – Specifies the ports to be displayed.
None.
: IPv6
: fe80::2c8:e7ff:fe88:5c95
: ifIndex
: 1.3.6.1.2.1.2.2.1.1
: (NONE)
244