KYMCO DINK 200i Service Manual page 353

16
. REAR BRAKE/REAR FORK/REAR
WHEEL/REAR SHOCK ABSORBER
DINK 200i/125
Install the rear wheel onto the final gear shaft,
aligning the spline.
Install the inner side collar.
Install the rear fork.
Install the rear fork and tighten the two bolts
(5) to the specified torque.
Torque: 27 N•m (2.7 kgf•m, 19 lbf•ft)
Install and tighten the rear axle nut (1) to
temporarily.
Install and tighten the rear shock absorber
lower mount bolt (2) to the specified torque.
Torque: 27 N•m (2.7 kgf•m, 19 lbf•ft)
Install the rear brake caliper and tighten the
two mounting bolts (4) to the specified
torque.
Torque: 32 N•m (3.2 kgf•m, 23 lbf•ft)
Install the brake hose clamps to the rear fork
and tighten the three bolts (3) securely.
Tighten the rear axle nut (1) to the specified
torque.
Torque: 120 N•m (12 kgf•m, 86 lbf•ft)
16-24