Throttle Body/Throttle Position Sensor - KYMCO DINK 200i Service Manual

14. DINK 200i:
THROTTLE BODY/THROTTLE
POSITION SENSOR (TPS)/IDLE
AIR BY PASS VALVE (ABV)
Turn ignition switch off and set up center
stand when do the replacement.
Check and confirm the battery voltage above
12V by a voltmeter after replacement.
Check and confirm the other connectors are
assembled correctly after replacement.
Do not damage the throttle body, this may
cause incorrect throttle and idle valve
synchronization.
The throttle body is factory pre-set, do not
disassemble it in a way other than shown in
this manual.
Do not loosen or tighten the painted bolts
and screws of the throttle body. Loosening
or tightening them can cause throttle and idle
valve synchronization failure.
REMOVAL/INSTALLATION
Turn ignition switch OFF.
Loosen the lock nut (1) and remove the adjust
nut (2), then disconnect the throttle cable (3).
Loosen intake manifold band screw (4) and
air ventilation hose band screw (5).
Disconnect throttle position sensor connector
(6) and idle air by pass valve connector (7),
then remove throttle (8).
Installation is in the reverse order of the
removal.
• •
To reset the ABV and APC when the
throttle body, air by pass valve, cylinder
head or cylinder is replaced (refer to the
"RESET THE AIR BY PASS VALVE
(ABV)" section in this chapter).
14-35
FUEL SYSTEM (Auto Control Fuel Injection System)