Maintenance Schedule - KYMCO DINK 200i Service Manual

3
. INSPECTION/ADJUSTMENT
TORQUE VALUES
Front axle nut : 6 kgf-m (60 N-m, 43 lbf-ft)
Rear axle nut : 12 kgf-m (120 N-m, 86 lbf-ft)

MAINTENANCE SCHEDULE

Perform the pre-ride inspection at each scheduled maintenance period.
This interval should be judged by odometer reading or months, whichever comes first.
I: INSPECT AND CLEAN, ADJUST, LUBRICATE OR REPLACE IF NECESSARY
C: CLEAN
The following maintenance schedule specifies all maintenance required to keep your scooter in
peak operating condition. Maintenance work should be performed in accordance with standards
and specifications of KYMCO by properly trained and equipped technicians. Your KYMCO dealer
meets all of these requirements.
Should be serviced by your KYMCO dealer, unless the owner has the proper tools and service
data and is mechanically qualified.
In the interest of safety, we recommend these items be serviced only by your KYMCO dealer.
KYMCO recommends that your KYMCO dealer should road test your scooter after each periodic
maintenance is carried out.
NOTE:
1 At higher odometer readings, repeat at the frequency interval established here.
2 Service more frequently if the scooter is ridden in unusually wet or dusty areas.
3 Service more frequently when riding in rain or at full throttle.
4 Clean every 2000 km (1200 mi) after replacement and replace every 5000 km (3000 mi).
5 Replace every 1 year, or every 4000km (2400mi), whichever comes first. Replacement requires
mechanical skill.
6 Replace every 10000 km (6000 mi), or once a year it at every 5000 km (3000 mi). Replacement
requires mechanical skill.
7 Replace every 2 years. Replacement requires mechanical skill.
8 Replace every 6000 km (3700 mi). Replacement requires mechanical skill.
R: REPLACE A: ADJUST L: LUBRICATE
DINK 200i/125
3-2