KYMCO DINK 200i Service Manual page 24

1. GENERAL INFORMATION
• •
Refer to the page 1-30 to understand the
fuel system wire routing of DINK 200i.
(1) Rear brake hose
(4) Fuel pump vacuum hose (DINK 125)
(6) Coolant temperature sensor wire (DINK 125)
(8) Throttle cable
(11) Auto choke connector (DINK 125)
(13) Harness wire
(16) Luggage box light connector
(18) Ignition coil (DINK 125) (19) Carburetor vacuum hose (DINK 125)
(20) Ignition coil cable
(A) Pass the seat lock cable through the guide.
(B) Pass the seat lock cable through the guide.
(C) Pass the AICV vacuum hose through the guide.
1-21
(2) Bleed hose
(9) Starter motor cable (10) Heater control connector (DINK 125)
(14) Seat lock cable
(3) AICV Vacuum hose
(5) Carburetor heater connector (DINK 125)
(7) Fuel pump fuel hose (DINK 125)
(12) Frame ground terminal
(15) Ground cable
(17) Side stand switch connector
DINK200i/125