KYMCO DINK 200i Service Manual page 289

14. DINK 200i:
INSTALLATION
Install the fuel pump being careful not to
damage the fuel pump wire and make sure the
fuel hose joint on fuel pump facing rear.
Tighten the bolts using crisscross pattern.
Connect the fuel hose, fuel vacuum hose and
fuel pump connector.
INSPECTION
Inspect the O-ring for damage.
Inspect the fuel strainer for clogged or
damage.
Inspect the each wire for wear.
Inspect the each wire lead for loose or
disconnected.
14-47
FUEL SYSTEM (Auto Control Fuel Injection System)