KYMCO DINK 200i Service Manual page 256

14. DINK 200 i:
Failure
Blinks
Codes
11 P0350 Ignition fault
12 P0230 Fuel-pump relay fault
13 P0219 Engine max over-speed fault
14 P1560 Transducer power supply fault
FUEL SYSTEM (Auto Control Fuel Injection System)
Fault description Priority Fault management
1.The confirmation light the front
line turn electric resistance
whether in the specification?
2.Does the confirmation light the
front line turn and deal with
contact, connect line and haven't
moved and break road?(the ECU
pin 12)
2
3.Does the confirmation light the
front line turn whether power
supply supply is normal or not?
4.If still appear an abnormality,
depend on to change whether the
new article process confirmation
light the front line turn an
abnormality or not?
1.Confirm the fuel pump and deal
with contact, connect line and
haven't moved and break road
after the electrical appliance?(the
ECU pin 5)
2
2.If still appear an abnormality,
change a new fuel pump to
confirm after the electrical
appliance whether fuel pump after
electrical appliance abnormality?
1.Turn soon exceed engine safe
enactment, reduce the engine
operation speed then cancellation
2
breakdown yard.
2.Does checking the CVT leather
belt split? Cause the engine lead
high turn soon.
1.Confirm the ECU pin 18 whether
output 5 V DC?
2.Confirm whether power supply
electric voltage is the 5 V DC or
not that each sensor knows the
machine connects line to carry?
(the ECU pin 18 and pin 16 it
2
press bad)
3.If the ECU output for the 5 V DC,
but still show'the sensor know the
machine power supply supply
abnormality' then depend on to
change new article process to
carry on ECU to change.
(Cont'd)
14-14