KYMCO DINK 200i Service Manual page 281

14. DINK 200i:
Check that the air should flow (A) to (B),
only when the 12-V battery is connected to
the idle air bypass valve terminals.
(Using diagnostic tool)
Enter RECIVE SIGNAL MENU (refer to the
"RECIVE SIGNAL MENU (USING
DIAGNOSTIC TOOL)" section in this
chapter).
Read page 04.
Check the value of "ABVOnTimeOfs (ms)"
is 0, if not perform the ABV reset (refer to the
"RESET THE AIR BY PASS VALVE
(ABV)" section in this chapter).
Read page 06
Start the engine to read ABV adaption
("ISCAdapMean (°)") and ABV open
duration ("ABVAngDurMech (°)") under any
engine speed rpm.
14-39
FUEL SYSTEM (Auto Control Fuel Injection System)