KYMCO DINK 200i Service Manual page 29

1. GENERAL INFORMATION
(1) Thermostat
(3) Fuel hose (DINK 125)
(5) Water hose (between the water pump and cylinder)
(6) Upper radiator hose (connect the thermostat)
(8) Rear brake hose
(10) O2 sensor connector (DINK 200i)
(A) Pass the rear brake hose through the guide.
(B) Pass the rear brake hose through the guide.
(C) Pass the fuel hose (DINK 125) and water flow hose through the guide.
(D) Pass the rear brake hose through the guide.
(E) DINK 200i: Pass the O2 sensor wire through the guide
(F) DINK 200i: Pass the O2 sensor wire, harness wire, starter motor cable and A.C.G. wire
through the guide
(2) Bleed hose (connect the thermostat)
(4) Water flow hose
(9) O2 sensor (DINK 200i)
(7) Lower radiator hose
• •
Refer to the page 1-30 to
understand the fuel system
wire routing of DINK 200i.
DINK 200i/125
1-26