Engine Control Unit (Ecu) - KYMCO DINK 200i Service Manual

14. DINK 200i:

ENGINE CONTROL UNIT (ECU)

REMOVAL/INSTALLATION
Do not disconnect or connect the ECU
connector during the ignition switch
"ON"; it may cause the ECU damage.
Connect the battery terminals topsy-
turvy may cause ECU damage.
Remove three bolts and disconnect ECU
connector, then remove ECU.
Keep out of water.
q
Remove the battery when the ignition
q
switch is ON may cause the ECU
damage.
Installation is in the reverse order of the
removal.
INSPECTION
ECU pin location and function in next
page.
(Using a commercially available
multimeter)
Input voltage
Turn ignition switch to OFF, and Disconnect
the ECU connector.
Turn ignition switch to ON.
Connect the multimeter (+) probe to the red
wire and the multimeter (-) probe to the green
wire.
There should be battery voltage at all times.
14-31
FUEL SYSTEM (Auto Control Fuel Injection System)