Sanding The Fuser Roll - Xerox 3001 Service Manual

Sanding the Fuser Roll
Purpose
The purpose is t o recondition the heat roll
surface to improve media feed through the
fuser.
Procedure
Use Scotch Brite or 220 to 300 grit abrasive
paper t o roughen the roll. Use light uniform
pressure while roughening the roll. Do not use
a circular motion but, use long straight strokes
over the length of the roll. Roughen the
complete surface, then clean with film
remover and apply oil over the surface.
12/98
Sanding the Fuser Roll
6-1 4 3001