Rep 10.1 1 - Xerox 3001 Service Manual

REP 10.1 1 OIL PADS
RELACEMENT Q
Ensure that the wick i s not wrinkled and
that the wick edge is a minimum of 518
PARTS LIST ON PL 10.3
REMOVAL
1. WARNING: DISCONNECT THE POWER
CORD.
Handle the Oil Dispense Assembly with
care to avoid bending the stripper
fingers and the media deflecton.
2. REMOVE THE OIL DISPENSE ASSEMBLY (REP
10.9).
3. (FIGURE 1): REMOVE THE OIL PADS.
REMOVE THE
B'
\ -
MOVE THE WICK
\
A
MOVE THE PLASTIC
COVER
Figure 1. Remove the Oil Pads
inch (14mm).
1. (FIGUREZ): INSTALLTHENEWOILPADS.
Q
STEP 2A: Ensure that the edge of the
plastic cover is under the edge of the
extrusion.
(2) AND
WICK UNDER
EXTRUSION
Figure 2. Install the New Oil Pads
(Continued)
12/98
REP 10.1 1
4-50 3001