C9 Foreign Accessory Rap - Xerox 3001 Service Manual

C9 Auditron RAP
The status code will be displayed if:
the auditron is enable and no user code i s
entered. The Auditron will indicate
READY
an incorrect user code is entered.
the Auditron is enabled but not
connected.
the enable signal is missing.
the AC power is disconnected
Enter a valid user code, the C 9 code is no
longer displayed. Explain to the user that the
C 9 code will be displayed as long as the
auditron
i s
enabled, but no user code i s
entered.
Ensure that the auditron power cord i s
connected.
Ensure that the copier to Auditron interface
harness is seated correctly.
Turn the key to the Bypass mode.
The C9 code is displayed.
Explain to the user that the C 9 code will
be displayed as long as the auditron i s
enabled, but no user code is entered.
A
Enter the code [39] and ensure that the,
Auditron is enabled.
Change the value to 2. This disables the
Auditron feature. Try t o make copies.
The copier makes copies.
Y N
I
Replace the Control PWB.
Go to FLAG 1 and check the wiring for an
open circuit.
If there is no open circuit, notify the
Customer that the Auditron is defective.
C9 Foreign Accessory RAP
The status code will be displayed if the
foreign accessory
is
not connected or the
enable signal is missing. Ensure that the
interface harness is seated correctly.
Enter the code [39] and change the value to
2. This disables the foreign accessory
feature. Try to make copies.
The copier makes copies.
Y N
Replace the Control PWB.
Go to FLAG 1 and check the wiring for an
open circuit.
If there is no open circuit, notify the
Customer that there is
a
problem with the
foreign accessory.
I
CONTROL PWB 1
12/98
3001 2-17
C9 CVAIAuditron RAP, C9 Foreign Accessory RAP