Rep 10.11 - Xerox 3001 Service Manual

(Continued) 3. (FIGURE 4): INSTALLTHE PLASTIC COVER
OVER THE OIL PADS.
2.
(FIGURE 3): INSERT THE WlCK EDGE UNDER
THE PLASTIC COVER. 4. INSTALL THE OIL DISPENSE ASSEMBLY.
Q
STEP 28: If the plastic cover is lifted too
far, the narrow edge will come out from
under the extrusion edge.
/
LIFT THE PLASTIC
OVE THE PLASTIC
EDGE OF THE EXTRUSION
(FULL LENGTH) WHILE DOING
THE STEP B
FOLD THE WlCK OVER THE OIL
PADS (FULL LENGTH) WHILE
DOING THE STEP B
Figure 3.
Insert the Wick Edge Under
the Plastic Cover
Figure 4. Install the Plastic Cover Over the Oil Pads
1 2/98
3001 4-51
REP 10.11