Rep 9.5 Developer Module - Xerox 3001 Service Manual

REP 9.5 DEVELOPER MODULE
3. REMOVE THE TONER CARTRIDGE.
PARTS LIST ON PL 9.4
STEPS 4 A AND 5 C: Do not lift the
Developer Module by the auger tube.
REMOVAL
4. (FIGURE 1): HAND POSITION FOR
REMOVING THE DEVELOPER MODULE.
0
Before removing the developer
module, ensure that there is a clear
area to place the assembly.
1. WARNING: DISCONNECT THE POWER
CORD.
2. REMOVE THE LEFT AND RIGHT SIDE
COVERS AND THE UPPER REAR COVER.
DISCONNECT
5. (FIGURE 2): REMOVE THE DEVELOPER
MODULE.
Q
STEP 5 B: When loosening, ensure that
the screw is loosened enough that the
end of the screw is inside the bracket to
avoid interference when removing the
developer module.
Q
LOOSEN
SCREWS (2)
ONE EACH
END
Figure 2. Remove the Developer Module
1 - 1
Figure 1. Hand Position for Removing the Developer Module
(Continued)
REP 9.5