A6 Document Handler Rap; A7 Document Handler Rap - Xerox 3001 Service Manual

A6 Document Handler RAP
The status code A6 will be displayed if there
is a document at the front document sensor
at the wrong time. This could occur if there
was a document at the front document
sensor when the fuser has warmed up.
Check the actuator of the front document
sensor for damage.
Enter the code [371 to check the front
document sensor. The Film LED will be lit i f
the sensor is blocked.
If the LED is lit all of the time, go to FLAG 1
and check the wiring for an open circuit.
If there is no open circuit, replace the front
document sensor.
A7 Document Handler RAP
The status code A7 will be displayed if the
document was less than 12 inches (305mm)
or more than 54 inches (1372mm) long and
the copier was in the multiple copies mode.
The document was not causing the actuator
to block the front document sensor while the
document was driven into the copier.
Enter the code [37] t o check the front
document sensor. The Film LED will be lit i f
the sensor is blocked.
Ensure that the document drive motor was
not binding. Check for damage to the drive
belt.
I
CONTROL PWB \
I
12/98
3001 2-1 I
A6, A7 Document Handler RAP