J 1 Lowtoner Fault Rap - Xerox 3001 Service Manual

Enter the code [ l o ] t o switch on the main
drive motor. After the main drive motor
is on, enter the code [ I 31 t o actuate the
toner dispense solenoid.
The toner dispense solenoid actuates.
Y N
Set the DMM t o the 2OOVDC scale
and connect the ( + ) lead t o PIJ 35,
pin 2 and the (-) lead t o PIJ 35. pin 1.
There is 24 VDC
Y N
Connect the ( + ) lead t o PIJ 65,
pin 8 and the
(-)
lead to PIJ 65,
pin 7.
There is 24 VDC.
Y N
I
Replace the Control PWB
(REP 3.1), then continue with
Path A.
Repair the wires, then continue
Path A.
Replace the Toner Dispense Solenoid
(REP 9.6). Perform the Toner
Dispense Solenoid Adjustment (ADJ
9.3), the continue with Path A.
Exit the diagnostics and perform the
Toner Dispense Solenoid Adjustment
(ADJ 9.5), the continue with Path A.
Perform Electrostatic Series, ADJ 9.3. Do not
perform the lmage Density Adjustment (ADJ
9.4) yet.
Enter the code [47] t o begin automatic tone
up. Listen for beep indicating that tone up
was successfully completed within the 15
minute time limit.
J 1
is displayed
Y N
D
E
D E
I
Perform the lmage Density Adjustment
(ADJ 9.5).
Refer back t o the Initial Actions section of
this RAP.
J1 Low Toner Fault RAP