E2 Media Jam Rap - Xerox 3001 Service Manual

E2 Media Jam RAP
This code is displayed if the logic thinks that
the Prefeed Sensor is blocked at the wrong
time. This could occur if the media is
inserted before the document is inserted and
the copier is in the multiple copies mode.
The circuit diagrams are on the next
Q
page.
Initial Actions
0
Check the Media path for
obstructions.
Procedure
Enter the code 1371 to check the Prefeed
sensor.
NOTE: The bond LED will be lit when the
sensor is blocked.
Actuate the Prefeed Sensor (47). The Bond
LED goes on then off when the sensor is
actuated.
Y N
Go to FLAG
1
and check the wiring for an
open circuit or a short circuit.
If there is no open or short circuit,
replace the Prefeed Sensor (47).
If the problem persists, replace the
Controller PWB.
if the problem persists, replace the
Controller PWB (A3).
E2 Media Jam RAP
2-24 3001