Fuser Roll - Xerox 3001 Service Manual

REP 10.2 FUSER ROLL
PARTS LIST ON PL 1 0.2
REMOVAL
2. REMOVE OIL DISPENSER ASSEMBLY (REP
10.9).
3. REMOVE THE RIGHT AND THE LEFT SIDE
COVERS, AND THE SEPARATOR GUIDES.
4. REMOVE XEROGRAPHIC MODULE (REP
FUSER ROLL
STEP
6 C: When removing the fuser roll,
be careful not t o damage the roll while
removing the roll through the side
frame of the xerographic module.
REPLACEMENT
STEP 6 C (FIGURE 1):
When installing a
@
new fuser roll or reinstalling the fuser
roll removed in this procedure, be
careful not to damage the roll while
installing the roll through side frame
of the xerographic module.
STEP 6 A (FIGURE 1): When reinstalling
Q
the (2) screws, ensure that the head of
the screw fits into the hole in the
Fuser
Roll.
1. REINSTALL THE FUSER ROLL (REP 10.2).
2. REINSTALLTHE HEAT ROD (REP 10.1).
3. PERFORM THE FUSER ROLL INITIALIZATION
PROCEDURE (3001 SERVICE MANUAL,
SECTION 6, GENERAL PROCEDURES).
1 2/98
REP 10.2
4-42
3001