Rep 9.3 Photoreceptor Drum - Xerox 3001 Service Manual

REP 9.3 PHOTORECEPTOR
DRUM
PARTS LIST ON PL 9.1
REMOVAL
1. WARNING: DISCONNECT THE POWER
CORD.
2. REMOVE THE SEPARATOR GUIDES, THE
RIGHT SIDE COVER, AND THE LEFT SIDE
COVER.
4. REMOVE PHOTORECEPTOR DRUM
ASSEMBLY (REP 9.2).
5. (FIGURE 1): REMOVE PHOTORECEPTOR
DRUM SHAFT.
REPLACEMENT
Do not remove the light shield until
Step 2 when the photoreceptor is
a
ready to be installed in the
xerographic module.
3. REMOVE THE XEROGRAPHIC MODULE
(REP 9.1).
R E M O V E SCREWS (3)
Figure 1. Remove Photoreceptor Drum Shaft
1. (FIGURE 2): INSTALL PHOTORECEPTOR
DRUM SHAFT.
Q
STEP
IA:
Ensure that the top of the drum
box is up before opening the box.
Q STEP
1
D: The end shields (2) must be raised
in order t o position the Drum shaft end
plates against the Drum fully.
Q
STEP 1 D: When installing the drum shaft,
be sure to tighten the three retaining
screws evenly and with equal pressure.
REMOVE
I \ /
I
'
LIGHT SHIELD
I
END SHIELD ( 2 )
I
/ / /
B
OPEN BOTH
ENDS
INSTALL (3)
I
i o y
Figure 2. lnstali rzr! Drum Shaft
I J R ~ S M ~
llrl
I
(Continued)
1
2/98
REP 9.3
4-24 3001