Ricoh Pro C9100 Operating Instructions Manual page 99

5. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 3 to 4. If the problem persists after the value in 102: [Fusing Nip
Width Adjustment: Envelope] is reduced to 400 milliseconds, contact your service
representative.
Procedure 2: Decrease the pressure roller temperature
1. In [Advanced Settings] for the custom paper, adjust the pressure roller temperature.
<Printing in full color>
Decrease the value in 090: [Fusing Pressure Roller Temp: FC] by 20 degrees.
<Printing in black and white>
Decrease the value in 091: [Fusing Pressure Roller Temp: BW] by 20 degrees.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 2. If the problem persists even though you have decreased the
value in 090: [Fusing Pressure Roller Temp: FC] or 091: [Fusing Pressure Roller
Temp: BW] to 30 degrees, contact your service representative.
• If decreased values affect fusibility, proceed to the solution in page 19 "Improving Fusibility".
• If a paper jam occurs when print is performed on envelopes, in [Advanced Settings] for the custom
paper you are using, adjust 123: [Fusing Belt Feed Speed] by 0.5%.
• After performing the solution, it is recommended to perform the color calibration of the external
controller. For details see, page 159 "Operating Procedure for Color Calibration".
Others
97