Ricoh Pro C9100 Operating Instructions Manual page 22

3. Specifying and Checking Paper Settings
Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
Procedure 1: Changing the fusing temperature
1. In [Advanced Settings] for the custom paper, adjust the fusing heat roller
temperature.
<Printing in full color >
Increase the value in 088: [Fusing Temp: FC] by 5 degrees.
<Printing in black and white>
Increase the value in 089: [Fusing Temp: BW] by 5 degrees.
2. Print the image and check toner fusion. Has the problem been resolved?
Yes
No
3. Repeat Step 2.
If the problem persists even if you increase the temperature to 190 degrees, perform
"Procedure 2: Changing the process speed".
Procedure 2: Changing the process speed
This will slow down the printing to give the toner more time to fuse. However, because of this,
throughput will be reduced.
For details about "Process Speed Setting", see "Details of Menu Items in Advanced Settings",
Adjustment Item Menu Guide.
1. In [Advanced Settings] for the custom paper, set 120: [Process Speed Setting] to
[Low].
2. Print the image and check toner fusion. Has the problem been resolved?
Yes
No
• Changing the fusing temperature or changing the process speed may produce one or more of the
following side effects:
• Paper curling
• Paper misfeeding
• Blister-like white spots
20
Finished!
Increase the temperature an additional 5 degrees.
Finished!
Contact your service representative.