7. Image Quality Problem: Full Page
2.
In [Advanced Settings] for the custom paper, specify the area to apply the paper transfer
current at the trailing edge of the paper values.
<Printing in black and white>
In 042: [Paper Transfer Current: TE Leng.: BW] or 068: [AC Transfer Mode: TE Leng.: BW],
enter the value which is 10 mm higher than the value measured in Step 1.
<Printing in full color>
In 048: [Paper Transfer Current: TE Leng.: FC] or 071: [AC Transfer Mode: TE Leng.: FC],
enter the value which is 10 mm higher than the value measured in Step 1.
3.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Proceed to "Procedure 2: Increasing the current".
Procedure 2: Increasing the current
1.
In [Advanced Settings] for the custom paper, make a note of the following values:
<Printing in black and white>
041: [Paper Transfer Current: TE: BW], 066: [AC Transfer Mode: Voltage: TE: BW], and 067:
[AC Transfer Mode: Current: TE: BW]
<Printing in full color>
047: [Paper Transfer Current: TE: FC], 069: [AC Transfer Mode: Voltage: TE: FC], and 070:
[AC Transfer Mode: Current: TE: FC]
2.
Increase these values by 10 percentage points.
3.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Increase the value by 5 percentage points.
4.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Proceed to "Procedure 3: Decreasing the current".
74