Ricoh Pro C9100 Operating Instructions Manual page 49

Cause:
This may occur if:
• Thick paper is used
• Coated paper is used
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
1. In [Advanced Settings] for the custom paper, check the present value in 087: [Ppr Trns
High Pressure Setting]. Is it set to [High]?
Yes No further improvement is likely. Contact your service representative.
No Set 087: [Ppr Trns High Pressure Setting] to [High] and go to the next step.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Carry out the procedure in see page 44 "Horizontal Streaks: When Using Thick Paper
(1)".
• Changing the value in 087: [Ppr Trns High Pressure Setting] may produce either or both of the
following side effects:
• Increase in toner consumption
• Occurrence of banding (streaks)
21 mm (0.8 in.)
DFT306
Streaks
47