Ricoh Pro C9100 Operating Instructions Manual page 106

8. Troubleshooting Paper Delivery Problems
To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
The solution varies depending on the 115: [Ppr Edge Detection: Sensing Duration] setting.
In [Advanced Settings] for the custom paper, check the 115: [Ppr Edge Detection: Sensing Duration]
setting. If it is set to [Long Time], proceed to " Procedure 1: If set to [Long Time]".
If it is set to [Short Time], proceed to " Procedure 2: If set to [Short Time]".
Procedure 1: If set to [Long Time]
1. In [Advanced Settings] for the custom paper, set the value in 116: [Ppr Edge Detection:
Sensitivity] to "3".
2. Print 50 sheets on one side. Has the jam code J098 appeared?
Yes
No
3. Print 50 sheets on one side. Has the jam code J098 appeared?
Yes
No
4. Decrease the value in 116: [Ppr Edge Detection: Sensitivity] by 0.5 points.
5. Print 50 sheets on one side. Has the jam code J098 appeared?
Yes
No
Procedure 2: If set to [Short Time]
1. In [Advanced Settings] for the custom paper, set the value in 116: [Ppr Edge Detection:
Sensitivity] to "3".
2. Print 50 sheets on one side. Has the jam code J098 appeared?
Yes
No
3. Print 50 sheets on one side. Has the jam code J098 appeared?
104
Increase the value in 116: [Ppr Edge Detection: Sensitivity] by 1 point and go to
the next step.
Skip to Step 4.
Repeat Step 2. If the problem persists even though you have increased the value
by "10", perform the following solution.
• Set 015: [Skew Detection] to [Off].
• Set 118: [Registration Adjustment: Across Feed] to [Deactivate].
Go to the next step.
Increase the value in 116: [Ppr Edge Detection: Sensitivity] by 0.5 points.
Repeat Steps 4 and 5.
Increase the value in 116: [Ppr Edge Detection: Sensitivity] by 1 point and go to
the next step.
Skip to Step 4.