Solution:
<Printing in black and white>
1.
In [Advanced Settings] for the custom paper, check the present value in 022: [Image
Transfer Current: BW]. Is it lower than 150 A?
Yes
Carry out all of the following:
• Increase the value by 5 A in 022: [Image Transfer Current: BW].
• Set 041: [Paper Transfer Current: TE: BW] to "200%".
• Set 042: [Paper Transfer Current: TE Leng.: BW] to "30 mm".
No
No further improvement is likely. Contact your service representative.
2.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Repeat Steps 1 to 2. If the problem persists even though you have increased the value
in 022: [Image Transfer Current: BW] to 150 A, contact your service representative.
<Printing in full color only>
1.
In [Advanced Settings] for the custom paper, check the present value in 023: [Image
Transfer Current: FC: K]. Is it lower than 150 A?
Yes
Carry out all of the following:
• Increase the value by 5 A in 023: [Image Transfer Current: FC: K].
• Set 047: [Paper Transfer Current: TE: FC] to "200%".
• Set 048: [Paper Transfer Current: TE Leng.: FC] to "30 mm".
No
No further improvement is likely. Contact your service representative.
2.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Repeat Steps 1 to 2. If the problem persists even though you have increased the value
in 023: [Image Transfer Current: FC: K] to 150 A, contact your service representative.
• Changing the transfer current may produce either or both of the following side effects:
• Increase in toner consumption
• Occurrence of banding (streaks)
Dirtied Printouts
91