5. Image Quality Problem: Lines
3.
Is it set to 150 A?
Yes
Proceed to "Procedure 2: Adjust the transferability at the paper transfer unit".
No
Go to the next step.
4.
Increase the value in 022: [Image Transfer Current: BW] or 023: [Image Transfer Current:
FC: K] by 5 A.
5.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Go to the next step.
6.
Specify the area to apply the image transfer current at the leading edge of the paper.
In 028: [Image Transfer Current: LE Leng.: BW] or 030: [Image Transfer Current: LE Leng.: FC: K],
enter the value which is 5 mm higher than the value measured in Step 1.
7.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Repeat Steps 4 and 5. If the problem persists even though you have increased the
value to 150 A, proceed to "Procedure 2: Adjust the transferability at the paper
transfer unit".
Procedure 2: Adjust the transferability at the paper transfer unit
1.
In [Advanced Settings] for the custom paper, set 087: [Ppr Trns High Pressure Setting] to
[High].
2.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Go to the next step.
3.
Increase the value in 084: [Ppr Trns Gap] by 1 step.
If [Off] is selected, change the value to [Small Gap]. If [Small Gap] is selected, change the value to
[Medium Gap]. If [Medium Gap] is selected, change the value to [Large Gap].
4.
Print the image. Has the problem been resolved?
Yes
Finished!
54