Ricoh Pro C9100 Operating Instructions Manual page 195

3. Select [Adjust Curl: Weak], [Adjust
Select the degree of decurling from "Weak", "Medium", and "Strong" according to the degree of
curling. If you cannot assess the degree of curling, try decurling in the order of "Weak", "Medium",
and "Strong". Decurling more than necessary may cause a paper jam, scratches, or sheets being
bent at corners.
Example 6: Jam code J040, J042, or J089 appears (upward curling)
Paper jam occurs at the separation claw due to paper curling, bending paper corners. This problem
occurs when thin paper of 52.3-80 g/m
Decurling method
Perform "Decurling Type 2" in Table 1 to decurl the paper downward when it enters the separation
claw.
1. In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled
Operators] menu, select 0301: [Adjust Paper Curl].
2. If the problem occurs on side 1 for single-sided or duplex printing, select [The paper tray'
name (1 Sided)]. If the problem occurs on side 2 for duplex printing, select [The paper
tray' name (2 Sided)].
For example, to decurl the paper fed from Tray 1, select [Tray 1 (1 Sided)] or [Tray 1 (2 Sided)].
3. Select [Adjust Curl: Weak], [Adjust
Select the degree of decurling from "Weak", "Medium", and "Strong" according to the degree of
curling. If you cannot assess the degree of curling, try decurling in the order of "Weak", "Medium",
and "Strong". Decurling more than necessary may cause a paper jam, scratches, or sheets being
bent at corners.
Example 7: Jam code J042 or J090 appears when printing is performed on one side
to deliver the paper with its printed side face down
When printing is performed on one side to deliver the paper with its printed side face down, the paper is
bent at corners when it is turned over. This problem occurs when thin paper of 52.3-80 g/m
Paper bent at corners will be delivered.
Decurling method
Perform "Decurling Type 1" in Table 1 to deliver the paper along the switch back guide plate.
1. In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled
Operators] menu, select 0301: [Adjust Paper Curl].
2. Select [The paper tray' name (1 Sided)].
For example, to decurl the paper fed from Tray 1, select [Tray 1 (1 Sided)].
Curl: Medium], or [Adjust
2
is used. Paper bent at corners will be delivered.
Curl: Medium], or [Adjust
Adjust Paper Curl
Curl: Strong].
Curl: Strong].
2
is used.
193