Ricoh Pro C9100 Operating Instructions Manual page 47

• The horizontal streaks which appear on thick paper do not appear on the first printed sheet.
• Streaks appear in various areas depending on the length and color of the paper.
Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
Procedure 1: Adjusting the gap of paper transfer
1. In [Advanced Settings] for the custom paper, check the present value in 084: [Ppr Trns
Gap].
2. Increase the value in 084: [Ppr Trns Gap] by one step.
If [Off] is selected, change the value to [Small Gap]. If [Small Gap] is selected, change the value to
[Medium Gap]. If [Medium Gap] is selected, change the value to [Large Gap].
3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 2 to 3. If the problem persists even though you have set 084: [Ppr Trns
Gap] to [Large Gap], revert the setting to the one in Step 1, and then proceed to
"Procedure 2: Changing process speed".
Procedure 2: Changing process speed
1. Set 120: [Process Speed Setting] to [Low] in [Advanced Settings] for the custom paper.
2. Print the image. Has the problem been resolved?
Yes Finished!
No If the problem persists, set 120: [Process Speed Setting] to [High], then proceed to
"Procedure 3: Adjusting intervals between sheets".
Procedure 3: Adjusting intervals between sheets
1. In [Advanced Settings] for the custom paper, adjust the value in 127: [Paper Feed Interval
Setting].
Adjust the length of intervals between sheets to move streaked areas to areas with no print image
or intervals between sheets. For instance, when performing black-and-white printing on A3 paper,
set this value to 54 percentage points to move the streak to the interval between sheets.
Streaks
45