Ricoh Pro C9100 Operating Instructions Manual page 165

2. Check the direction of the skew.
3. In the 01: [Machine: Image Position] group on the [Adjustment Settings for Skilled
Operators] menu, select 0107: [Perpendicularity Adjustment] and adjust the value.
Move the cursor to [+] to skew the image counterclockwise or to [−] to skew it clockwise.
4. Print the image in black and white. Check the image skew. If the problem persists,
increase the value slightly.
5. Execute color registration.
In executing color registration, the black adjustment will also be applied to cyan, magenta,
and yellow.
For details about color registration, see "When the Color Registration Shifts" in the
Troubleshooting guide supplied with the machine.
• In 0107: [Perpendicularity Adjustment], you cannot individually adjust the image position on
sides 1 and 2.
(b) Adjust the image position (If custom paper is used)
Adjust the vertical and horizontal image position so that the center (A) of the leading edge of the
image is aligned to the registration mark.
A
In [Advanced Settings] for the custom paper, adjust the image position.
• 001: [Image Position: Across Feed: Side 1]
• 003: [Image Position: With Feed: Side 1]
(c) Adjust the magnification (Across feed direction)
Adjust the horizontal magnification to adjust the width between the front (B) and back corners (B)
on the leading edge of the image.
Adjusting the Image Position of the Either Side of the Paper
DFP492
163