Ricoh Pro C9100 Operating Instructions Manual page 171

It is necessary to specify the settings for each paper size being used. The adjusted settings are stored as
custom paper presets and can be applied again in the future.
To adjust the image position, the machine administrator privilege is required.
Supported paper size and paper type
Supported Paper Size
A3 , A4 , A4 , B4 , B5 , B5 , DLT , Legal , Letter , Letter , Government LG , 8K ,
16K , 16K , 12 × 18 , 13 × 19.2 , 13 × 19 , 13 × 18 , SRA3 , SRA4 , SRA4
Unsupported Paper Type
Index paper, tracing paper, label paper, envelope, magnet paper, clear file
• There is no limit to paper thickness.
Preparation
To adjust the image position, you need to:
• Prepare a 500 mm or longer stainless steel ruler (with the scale in 0.5 mm) and magnifier (for
measuring the format)
• Check the supported paper size and paper type.
• From the supplied CD, print the file of the format matching the size of the paper requiring image
position adjustment.
• Adjust the image position on Side 1. For details about adjusting the position, see page 162
"Adjusting the Image Position on Side 1".
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
• In [Advanced Settings] for the custom paper, set the value in the following settings to "0.000".
002: [Image Position: Across Feed: Side 2]
004: [Image Position: With Feed: Side 2]
006: [Magnification: Across Feed: Side 2]
008: [Magnification: With Feed: Side 2]
• In [Advanced Settings] for the custom paper, note the values in the following settings, and then
adjust the value on one side to match the larger value on the other side.
013: [Erase Margin: Leading Edge]
014: [Erase Margin: Trailing Edge]
Adjusting the Image Position of the Either Side of the Paper
169