Ricoh Pro C9100 Operating Instructions Manual page 98

7. Image Quality Problem: Full Page
• A3 or DLT size paper is used
• An envelope is used
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
If no envelope is used, follow Procedure 1 and Procedure 2 as specified. If an envelope is used, carry
out "Procedure 1: Decrease the nip width" only. Terminate the sequence as soon as the problem is
resolved.
Procedure 1: Decrease the nip width
When printing on paper other than envelopes:
1. In [Advanced Settings] for the custom paper, set 092: [Fusing Nip Width Setting] to
"3".
2. Print the image. Has the problem been resolved?
Yes
No
3. Print the image. Has the problem been resolved?
Yes
No
When printing on envelopes:
1. In [Advanced Settings] for the custom paper, set 092: [Fusing Nip Width Setting] to
"1".
2. Increase the value in 123: [Fusing Belt Feed Speed] by 5%.
3. Decrease the value in 102: [Fusing Nip Width Adjustment: Envelope] by 50
milliseconds.
4. Print the image. Has the problem been resolved?
Yes
No
96
Finished!
Set 092: [Fusing Nip Width Setting] to "2".
Finished!
Set 093: [Fusing Pressure Roller On Before Fusing] to [Off] and proceed to
"Procedure 2: Decrease the pressure roller temperature".
Finished!
Decrease the value in 102: [Fusing Nip Width Adjustment: Envelope] by another
50 milliseconds.