• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
1.
In [Advanced Settings] for the custom paper, adjust the fusing heat roller temperature.
<Printing in full color>
Decrease the value in 088: [Fusing Temp: FC] by 5 degrees.
<Printing in black and white>
Decrease the value in 089: [Fusing Temp: BW] by 5 degrees.
2.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Decrease the value by 5 degrees in 088: [Fusing Temp: FC] or 089: [Fusing Temp:
BW].
3.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Set 120: [Process Speed Setting] to [Low].
4.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Decrease the value by 5 degrees in 088: [Fusing Temp: FC] or 089: [Fusing Temp:
BW].
5.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Decrease the value by 5 degrees in 088: [Fusing Temp: FC] or 089: [Fusing Temp:
BW].
6.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Contact your service representative.
Uneven Density
83