Ricoh Pro C9100 Operating Instructions Manual page 55

20 mm (0.8 in.)
Cause:
This may occur if:
• Thick paper is used
• Coated paper is used
• Printing is done at low temperature or humidity
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
Procedure 1: Adjust the image transfer current
1. Measure by a ruler or other device the length (in mm) of the area from the leading edge
of the paper where the paper is affected by thick density, insufficient density, toner
blasting, or streaks.
2. In [Advanced Settings] for the custom paper, check the present value of the current for the
image transfer roller.
<Printing in black and white>
Select 022: [Image Transfer Current: BW].
<Printing in full color>
Select 023: [Image Transfer Current: FC: K].
DFT056
Bands
53