DURKOPP ADLER 745-35-10 D Operating Instructions Manual page 224

Error code Symbol
9014
9015
9501
9601
9604
9605
9700
9701
9702
9703
9704
9707
9708
9709
9720
9721
9722
9723
222
Meaning
Position of transport clamp
doesn't match the installed die
Wrong adjustment of flap
scanning in the seam program
Test step by step
Pedal was pressed backwards
during sewing
Light barrier for sewing material
removal not active
Transport clamp moves
Folder not up
Folder not down
Folder not vertical
Folder not slanted
Folder not on the pipe table
Scissors not down
Scissors not up
Downholder not up
Error during flap scanning with
light barrier
Flap has been positioned in front
of the front positioning point
Flap projects beyond the
maximum sewing area (behind
the rear positioning point)
Fluff at the flap beginning
Operating Instructions 745-35-10 D - 00.0 - 04/2017
Troubleshooting
Remedial action
Correct position of transport clamp
in the seam parameters
 p. 102
Correct seam program
Use pedal for progress
Press pedal again
Set light barrier for sewing material
removal
Correct folder setting
Correct folder setting
Correct folder setting
Correct folder setting
Correct folder setting
Correct the scissors setting
Correct the scissors setting
Correct the downholder setting
• Check reflecting foil
• Check alignment of the light
barriers
Insert the flap correctly
• Check flap size
• Insert the flap correctly
• Insert flaps with smooth edges
• Check reflecting foil