Using the On-Screen Menu System
The on-screen (OSD) menus are used primarily for the initial setup of the device. The
on-screen menu presents configuration options on a local monitor, and settings can be
adjusted with front panel controls.
NOTES:
Menu Selection Buttons
1 1
2 2
Figure 15.
•
•
•
The on-screen menu has a default timeout of 60 seconds.
•
•
The screen examples shown in this section show the OSD screens of an
IN1808 IPCP SA. The OSD for your product may differ slightly.
3 3
5 5
6 6
MENU
4 4
ENTER
HOLD
FOR 720p/1080p
Menu Selection Buttons
Menu button — Press the
on-screen menu, deselect a submenu, or cancel a pending change.
Enter button — Press the
submenus, or submenu items, or to accept pending changes.
Navigation buttons — Press these buttons to navigate through the menu system:
>
Press the
(
) (
) or the
3
•
Up
submenu items.
Press the (
) arrow button (
•
Right
submenu items.
Press the (
) (
•
Left
6
submenu items. You can also use the navigation buttons to adjust settings
according to specific setting directions.
IN1806 and IN1808 Series Scaling Presentation Switchers • Operation
button (see figure 15,
Menu
button (
) to access the on-screen menu, select
Enter
2
<
(
) (
) arrow button to navigate submenus or
4
Down
) to access currently selected submenus or
5
) arrow button to exit currently selected submenus or
) to activate or exit the
1
26