Extron electronics IN1806 Series User Manual page 68

X5! = Video signal status
X5& = Remote port number
X5* = Baud rate, RS-232 port
X5( = Parity
X6) = Data bits
X6! = Stop bits
X6@ = Power Save mode
X6# = Screen saver status
X6$
= Port timeout
X6% = Start point for UART ports
X6^ = DTP remote power
X6& = Twisted Pair format
X6( = Hot plug change or detection
X7) = Key effect variable
X7! = Key effect setting
IN1806 and IN1808 Series Scaling Presentation Switchers • SIS Configuration and Control
0 = Video, TMDS, or DP signal not detected
1 = Video, TMDS, or DP signal detected
1 = Remote port (3-pole captive screw)
7 = Universal asynchronous receiver-transmitter (UART)
on DTP Input 7 (IN1808 Series only)
8 = Universal asynchronous receiver-transmitter (UART)
on DTP Input 8 (IN1808 Series only)
9 = UART on DTP/HDBT Output 1B
300, 600, 1200, 1800, 2400, 3600, 4800, 7200, 9600
(default), 14400, 19200, 28800, 38400, 57600, or
115200
Odd, Even, None (default), Mark, Space
Only the first letter is required.
7 or 8 (default)
1 (default) or 2
0 = Full power mode (default)
1 = Lowest power state — TP remote power and over
TP functions are disabled.
2 = Low power state — Over TP and TP remote power
are enabled.
0 = Active input detected, timer not running
1 = No active input, timer running, output sync still active
2 = No active input, timer expired, output sync disabled
Set time in increments of 10 seconds before the port
connection times out.
1 (10 seconds) through 65000 (650,000 seconds)
Default = 30 (300 seconds)
Start point for UART ports:
X6%
Rear panel RS-232 =
X6%
TP IN 7 = + 1 (IN1808 Series only)
X6%
TP IN 8 = + 2 (IN1808 Series only)
X6%
TP OUT 1B = + 3
Default = 2000, meaning:
IN7 = 2001
IN8 = 2002
TP OUT1B = 2003
0 = No remote power (default)
1 = DTP — 12 VDC
2 = DTP2 — 48 VDC
0 = DTP format (default)
1 = XTP format
2 = HDBaseT format (supported on output only)
0 = A sink has been removed (HPD deasserted).
1 = A new sink has been connected (HPD asserted).
0 = Transparency (available only when
1 = Red of RGB key (available only when
2 = Green of RGB key (available only when
3 = Blue of RGB key (available only when
4 = Level key
0 through 255
X7@
= 1)
X7@
= 2)
X7@
= 2)
X7@
= 2)
60